Jenn-Air JF36NXFXDE Manuel d'installation télécharger pdf (Page 21)

Move Refrigerator to

Final Location

IMPORTANT:

■ A flush installation is NOT possible with a 24" (60.9 cm) deep

opening.

■ To avoid floor damage, make sure levelers are raised (not

touching floor) and refrigerator is on rollers before moving.

■ Use the installation block, attached to the door hinge, as a

reference to make sure the refrigerator is pushed back far

enough into the opening, so that when the panels are installed

they will be flush with the adjacent cabinets.

■ After the refrigerator is leveled and aligned, remove the

installation block from the door hinge and use it to check the

spacing between the panels and adjacent cabinets.

NOTE: The installation block is designed to provide accurate

spacing for ³⁄₄" (1.9 cm), ³⁄₈" (9.53 mm) and ¹⁄₈" (3.18 mm).

1. Place top of cardboard carton or plywood under refrigerator.

Remove dolly.

2. Move the refrigerator straight back and evenly into the

opening. Be sure that the water tubing is not kinked and the

power supply cord is on top of the refrigerator.

NOTE: If the power supply cord is behind the refrigerator, it

will not install properly.

3. Make sure the installation block is flush with the adjacent

cabinets.

NOTE: To achieve a flush installation, it is critical to verify a ³⁄₄"

(1.9 cm) depth from the front face of the adjacent cabinetry to

the refrigerator.

Level and Align Refrigerator

IMPORTANT: All four leveling legs must contact the floor to

support and stabilize the full weight of refrigerator. Rollers are for

moving refrigerator and not for permanent support.

After moving the refrigerator to its final location:

1. Use a ⁵⁄₁₆" socket driver to turn the leveling bolts clockwise to

extend the legs to the floor as shown. The rollers should be off

the floor.

2. Adjust the leveling legs to level and align the refrigerator from

left to right and front to back so that the refrigerator is level

and aligned with the cabinets.

3. Continue adjusting the leveling legs until the top of the

refrigerator is making contact with the bottom of the solid

soffit, or the bottom of the anti-tip boards, if anti-tip boards

were used. Do not crush the compressor cover.

WARNING

Tip Over Hazard

Refrigerator is top heavy and tips easily when not

completely installed.

Keep doors taped closed until refrigerator is

completely installed.

Use two or more people to move and install

refrigerator.

Failure to do so can result in death or serious injury.

¹⁄₈"

(3.18 mm)

³⁄₈"

(9.53 mm)

³⁄₄"

(1.9 cm)

A. Adjacent cabinet or wall

B. Installation block

C. Face of refrigerator

A. Rear leveling bolt

B. Front leveling bolt

³⁄₄" (1.9 cm)

WARNING

Tip Over Hazard

Refrigerator is top heavy and tips easily when not

completely installed.

Keep doors taped closed until refrigerator is

completely installed.

Use two or more people to move and install

refrigerator.

Failure to do so can result in death or serious injury.

A B

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Jenn-Air JF36NXFXDE Manuel d'installation Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Jenn-Air JF36NXFXDE